Beko Arcelik BLG15 C7S, Service Manual, Page: 62 / 72

BLG15 C7S SERVICE MANUAL
Sensitivity: Public
6.14
Interference Suppression Filter Installation/Removal

Remove the upper table.

Interference suppression filter cable terminals are removed.

2 screws at the back of the body attaching the terminal assembly to the body are
removed.

Remove the interference suppression filter from the cable tabs connected to the
terminal assembly and by unscrewing the plastic screw connected to the body.
Picture 6.95 Interference suppression filter installation/removal
6.15
Washing Motor
6.15.1 ATLAS motor
Picture 6.96 Motor Picture 6.97 Motor

Rear wall is removed. Poly V belt is removed.

Motor-Drum connection screws are removed (2 pieces).

Motor is connected to the drum at three points; 2 in the front and 1 in the back.

Power and communication connections are removed.

During installation, check if the rear connection and the rubber gasket on it are
seated well.