BEKA Train Assembly Instructions Download Page 1

Manufactured by Beka, Inc.  •  542 Selby Avenue  •  St. Paul, Minnesota  55102  •  USA 

1-888-999-2352  •  www.bekainc.com   •  651-222-3965 fax 

Contents: 

 

4 table legs                   2 table ends 
1 center support bar     2 sides 
dowel rods                    20 screws 
top (optional) 
 
You will need a phillips screwdriver. 
Read instructions completely before beginning. 
 

 

Step 1:   

 

Assemble 

legs

 and 

ends 

into “U” shaped sections: 

 

Position 2 

legs

 and 1 

end

  so holes in the ends line 

up with holes in the “edge” of each leg.  Be careful 
to orient 

end

 so the 2 holes drilled through it’s cen-

ter are close to the edge that will be down (closer to 
the floor) when the table is positioned upright (see 
arrow).  Use a phillips screwdriver and 4 screws to 
fasten the 

legs

 to the 

end

 piece.  (see photo)  Repeat 

this with remaining 

legs

 and 

end 

piece.  You now 

have 2 “U” shaped sections that can stand on their 
own. 
 

 

Step 2:    

 

Connect the two leg/end sections together with 
the center support bar: 

 

Position the 2 sections assembled in step 1 so they 
are opposite each other.  Use 4 screws to attach the 
center support bar, connecting the two sections.  
The center support bar will be fairly flush with the 
bottom edge of the table ends.  The screws will pass 
through holes drilled in the center of each end piece, 
then into holes drilled in the support bar ends. 

Train and Activity Tables 

 

Assembly Instructions 

Step 1 

Step 2 

WARNING—ADULT ASSEMBLY REQUIRED! 

Enclosed hardware includes sharp points and small parts, so 

may present hazards to children prior to assembly. 

After assembly, an adult should check hardware 

periodically to insure it is tight 

Dispose of plastic bags and any extra hardware to avoid  

potential choking hazards. 

Train Table 

Reviews: