Beka Hospitec 921077000, Original Manual

Page: 33 / 60

Operation
Operating manual NORA Pro V0.1 E Page 33 of 60
CAUTION •
Do not stand between the sit-to-stand lift and an obstacle during
the transfer procedure.
•
During the movement of the sit-to-stand lift, the carrier frame must
be closed.
10. The steering of the NORA is enhanced when the carrier frame is not spread.
11. Release the brakes to transfer the patient/resident.
Preparation for lifting Lifting the patient /
resident
Transferring the patient /
resident
8.4 Putting the patient/resident down
When you have reached the desired location, you can put the patient/resident e.g. on a
chair or in bed. Proceed in the following manner:
1. Spread the carrier frame if needed up to the maximum possible spread width.
2. Bring the sit-to-stand lift with the patient/resident over the intended location.
3. Check that the chair or the bed stands safely; activate the brakes of the
wheelchair if required.
4. Lower the lifting arm with the spreader bar until the patient/resident sits safely in
the chairs or on the bed and the loops of the sling are relieved.
5. Remove the loops or the clips of the sling from the spreader bar.
6. Pull the sit-to-stand lift away from the patient. Make sure to pull the sit-to-stand
lift straight backwards to avoid injuring the patient with the spreader bar. If
required, raise the spreader bar to avoid injury of the patient/resident.
7. Put the sit-to-stand lift at a safe location.
8. Remove the sling from the patient/resident.