RD-EK32 Series User Development manual
12
C Set up mode operation procedure
1.
Install the printing paper
2.
按住打印机
Feed
键
(
双键按
LF),
接通电源
.
打印机打印自检
.Press the Feed button(double button press
LF),Power on, the printer start self printing test.
3.
打印机自检完成后
,
连续
10
次按下按键
,
打印机进入设置模式
,
并且打印出当前第一设置项的当前设
置内容
.After the self test finished, Press 10 times of button, the printer enter into set up mode, and print
out the present setting.
4.
按键每按下一次
,
设置项的参数相应的进行更改
,Press down the button each time, the parameter will
change accordingly.
5.
如果要设置下一个项目的参数
,
连续按键
2
次
,
进入设置下一项目
.If need to set the next item
parameter, press the button 2times continuously and enter into next item set up
6.
连 续多 次
(
大于
10
次 及以 上
)
按下
,
打 印机 恢复默 认值
.Continuous repeat pressing button(over
10times),the printer restore default.
7.
打印机恢复默认值后
,
再次连续
2
次按下按键
,
进入设置状态
After restore default, again press 2times
of button, the printer enter into set up status.
8.
断电打印机自动保存设置数据
.When power off, the printer save the set up data automatically
9.
详细流程图如下
:Detailed flow chart is as follows:
