Beijer Electronics korenix JetWave 3220v3 Series, User Manual

Page: 30 / 141

JetWave 3220v3/3420v3 Series User Manual
Page 21
Antenna Installation
The figure shows the direction to lock the antenna, it is
clockwise direction. There is Nylock pasted on the antenna
to avoid antenna loosen in vibration environment, please
don’t often lock/un-lock the antenna, otherwise, the Nylock
paste will be damaged.
Use the same way to lock the
attached WIFI antennas, it is
clockwise direction as well. Note that
the counter-clockwise direction will
loosen the antenna immediately.
For vibration environment , we don’t recommend you connect the antenna directly to the
device, no matter how heavy you lock it. It is suggested you install the antenna at non-vibration
or low vibration place and connect it by extended Radio cable antenna to the device.
In another practical case, we usually mount the device within the field box to protect water, rain
or other reasons, and mount its antennas outside the box. This is because the radio signal MUST
be filtered by the metal field box if you install the AP within the box.
Korenix provides the external antenna mounting kit, extended radio cable, celling mounting kit
as optional accessory. While you need it, you can purchase from Korenix.
For how to mounting the antenna plate and celling-mount plate, please refer to the chapter 2.6.