INTELLIGATE IG9
A50-61013-00001
Thank you for showing your confidence in us by purchasing the BEHRINGER INTELLIGATE IG9. This
ultimate effects pedal is specifically designed to achieve super-effective noise suppression without signal
deterioration. It ensures high signal integrity through a very fast attack time, program-adaptive release time
and frequency-selective noise suppression.
A noise gate increases the dynamic range of a signal by suppressing unwanted noise which is cut out
when the instrument signal drops below a certain threshold level. Furthermore, the IG9 has a selectable
filter cut-off point for frequency-selective noise suppression ensuring inaudible dynamics enhancement and
ultra-transparent tone.
CONTROLS
1.
Top view
Use the
{1}
THRESHOLD
switch to select a threshold range which suits your signal. In the upper position
(HIGH) the sensitivity is high and the gate only cuts out very low-level signal portions. In the lower
position (LOW) the sensitivity is low and the gate is more often cutting off.
Turn the
{2}
THRESHOLD
control to precisely set the threshold value above which the signal will remain
unaffected.
The
{3}
GATE
selector determines the frequency range that is cleaned by the IG9. Set it to HIGH to gate
out the signal of instruments with high-frequency boost as in the case with clean guitar and keyboard.
Use the MID position to clean the signal of sources with midrange-frequency boost as, for example,
with distorted guitar. In both cases low-frequency signals will remain unaffected. Select the FULL
position for signals with hum or buzz problems like the output of a guitar effects rack. The intensity of
the GATE LED above the selector indicates the level of noise reduction.
The LED illuminates when the effect is activated. It also serves as a battery level indicator.
{4}
Depress the footswitch to activate/deactivate the effect.
{5}
Use this 1/4" TS
{6}
IN
connector to plug in the instrument cable.
The 1/4" TS
{7}
OUT
connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
To install or replace the 9 V battery (not included), remove the bottom side of the unit taking the four screws
off.
The IG9 has no on/off switch. As soon as you connect the jack to the in connector, the IG9 is
+
switched on. When the IG9 is not being used, remove the jack from the in connector to extend
the battery life.
The
SERIAL NUMBER
is located on the bottom side of the device.
WARRANTY
2.
For our current warranty terms, please refer to our website at http://www.behringer.com.
