INSTRUCTIONS
INSTALLATION
WALL MOUNT - SINGLE FACE:
1. Extend unswitched 24 hour AC supply of rated voltage to junction box or appropriate wiring (supplied by others).
Leave at least eight (8) inches of slack wire. The circuit should not be energized at this time.
2. Remove the exit sign faceplate with a slotted screwdriver by depressing the tabs at the top of the sign. Take care not
to damage the red fiber which is loose behind the exit face.
3. Remove the exit sign universal canopy kit.
4. Knock out the appropriate mounting pattern and/or wire pass-thru hole on the exit back plate to fit the junction box
or wiring connector being used (supplied by others).
5. Bring wires through the back of the sign and mount the exit securely in place. Screw directly to junction box if
possible.
6. Connect supply (Figure 3) as follows:
Red - Line 347 volt; Black - Line 120 volts; White - Neutral; Green - Ground. For 277 volt use orange wire. Cap any
unused wires.
Insulate unused wire! CAUTION! - Failure to insulate unused wire may result in a shock hazard
or unsafe condition as well as equipment failure.
7. Route wires and secure them in place.
8. Remove or replace any directional chevron arrows to be indicated as required from the exit stencil.
9. Replace the exit faceplate together with the red fiber by snapping the face to the body.
10. Turn on the AC voltage supply.
Esco Exit (ECE)
926000132
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Disconnect power before performing work on electrical equipment.
3. Do not use outdoors.
4. Use caution when servicing batteries.
5. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to
tampering.
6. The use of accessory equipment not recommended by Beluce Canada Inc., may cause an unsafe condition, and
will void the unit’s warranty.
7. Do not use this equipment for other than its intended purpose.
8. Servicing of this equipment should be performed by qualified service personnel.
9.
SAVE THESE INSTRUCTIONS!
Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673
04/09/2019
