Installation and Technical Information
BEGA
In the interest of product improvement, BEGA reserves the right to make technical changes without notice.
Replacement Parts
Accessories
Please refer to the appropriate
accessory installation sheet for
further instruction when applicable.
180° Glare Shield
70 755
Elliptical Spread Lens
70 050
BEGA
1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 Fax (805)566-9474 www.bega-us.com © Copyright BEGA-US 2017
Figure 1
Figure 2
Small scale floodlight with mounting canopy
77 682
Tools Required:
5mm hex key
3mm hex key
Flat head screw driver medium
Phillips head screw driver medium
Protection Class:
IP65
Weight:
4.0 lbs.
Dimensions
A:
5-1/2 ”
B:
8 ”
C:
5-1/2 ”
D:
3-7/8 ”
Relamping/Maintenance
Remove trim and lens by loosening screws. Clean
luminaire and lens using only solvent-free cleansers.
Replace trim and lens. Tighten screws.
Lamp:
13.9W LED Module
77 682
7/10/2017
Page 1 of 2
Description
Lens
Lens gasket
Driver
LED (4000K)
LED (3000K)
Part No
140851
831279
76097
LED-0623/940
LED-0623/930
Notice to Installer for 77 682:
1. See page 2 for specific product safety warnings.
2. Integral LED driver supplied by BEGA.
3. Luminaire mounts directly to standard recessed 4” octagonal wiring (by
others), using mounting plate provided.
4. Do NOT remove moisture absorption packet from luminaire housing.
77 682 - installation:
1. Loosen the (1) 3mm hex screw on the luminaire canopy and remove
luminaire base from luminaire.
2. Feed luminaire wiring through the luminaire base and mounting plate.
3. Make supply wiring and luminaire wiring connections inside the wiring box (by
others):
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN GROUND WIRE TO GREEN LUMINAIRE WIRE
Dimming (if applicable):
DIMMING CONTROL WIRE (+) TO POSITIVE DRIVER DIM CONTROL
WIRE
DIMMING CONTROL WIRE (-) TO NEGATIVE DRIVER DIM CONTROL
WIRE
4. Attach provided mounting plate directly to a 4” standard octagonal wiring box
using the (2) screws (provided). Place a small bead of silicone around the back
side of the mounting plate that will come in contact with the finished surface
(exterior applications only).
5. Align and position mounting plate on mounting surface to correspond with
specified mounting orientation.
6. Slip luminaire base over the mounting plate. Tighten nuts on the studs
(provided) to secure.
7. Replace luminaire canopy (with luminaire attached) and tighten (1) set screw.
8. To adjust head angle, use 5mm hex key to loosen adjustment screw. Adjust
luminaire head as needed and tighten adjustment screw.
