Installation and Technical Information
BEGA
Replacement Parts
BEGA
1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 Fax (805)566-9474 www.bega-us.com © Copyright BEGA-US 2018
In the interest of product improvement, BEGA reserves the right to make technical changes without notice.
Accessories
Please refer to the appropriate
accessory installation sheet for
further instruction when applicable.
In-grade surface mounted LEDs - 180° output
77 089
Tools Required:
6 mm hex key
Phillips medium screwdriver
Weight:
6.4 lbs.
Dimensions
A:
10-1/2 ”
B:
2-1/4 ”
Relamping/Maintenance
Clean glass using only solvent-free cleaners.
77 089
5/15/2018
Page 1 of 2
Description
LED Driver (120-277V)
LED module (3000K)
LED module (4000K)
Part No
76023
LED-0258/830A
LED-0258/840A
Lamp:
5.9W LED Module
Figure 1
Figure 2
Figure 3
Notice to Installer for 77 089:
1. See page 2 for specific product safety warnings.
2. This product must be installed in accordance with the applicable installation code by
a person familiar with the construction and operation of the product and the hazards
involved.
3.
BEGA luminaires may be damaged if connected to conduit systems containing water -
Article 300- 5G of National Electric Code requires that “Conduits or raceways through
which moisture may contact energized live parts shall be sealed or plugged at either or
both ends”.
4. Seperate wiring box suitable for wet locations provided by BEGA.
5. A level surface MUST be provided for proper installation (Figure 1).
6. For vehicular loads, back box must be anchored to a suitable, load bearing foundation.
In all other applications, foundation should be sufficient to support anticipated load onto
fixture.
NOTE:
THE LUMINAIRES MUST NOT BE INSTALLED IN TRAFFIC LANES
WHERE THEY ARE SUBJECTED TO HORIZONTAL PRESSURE FROM
VEHICLES BRAKING, ACCELERATING, AND CHANING DIRECTION.
7. Proper drainage MUST be provided. Failure to do so may cause damage to
luminaire and void warranty.
8. When installing the fixure in organic mulch, surround wiring box with approximately 6” of
sand or other non-organic material
Wiring Box (Included) - Installation:
1. Establish location of wiring box.
2. Connect wiring box to 1/2” NPS plastic or steel conduit using a suitable thread sealer. Pull
supply wiring into wiring box for later electrical connections.
3. Establish proper foundation for wiring box (by others) based on anticipated loads to
the fixture. Use mounting holes provided on wiring box flange to anchor the wiring box to
suitable foundation.
4. Ensure finished surface is flush with the top edge of the wiring box.
77 089 - Installation:
1. Orient fixture on wiring box based on desired direction of illumination. (Figure 2)
2. Make luminaire and supply wiring connections using box using water tight wire connector
(provided):
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN GROUND WIRE TO GREEN LUMINAIRE WIRE
Dimming (if applicable):
DIMMING CONTROL WIRE (+) TO POSITIVE DRIVER DIM CONTROL WIRE
DIMMING CONTROL WIRE (-) TO NEGATIVE DRIVER DIM CONTROL WIRE
NOTE:
WIRE CONNECTIONS MUST BE KEPT DRY
3. Unscrew (2) screws on outer housing to remove base plate (Figure 3).
4. Attach base plate to wiring box using hardware provided.
5. Re-attach outer housing to base plate and secure using (2) screws.
NOTE:
The junction box DOES NOT have a gasket. Installer should seal around
the lip of the fixture and the ground to prevent water entry into the junction box.
