background image

Installation and Technical Information

BEGA

Accessories

Please refer to the appropriate

accessory installation sheet for

further instruction when applicable.

In the interest of product improvement, BEGA reserves the right to make technical changes without notice.

Replacement Parts

BEGA  

1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 Fax (805)566-9474 www.bega-us.com © Copyright BEGA-US 2019

Surface wall w/ cutoff optics

22 228

Tools Required:

3mm hex key

Standard medium screw driver

Phillips screw driver

Protection Class: 

IP65

Weight:

  1.5 lbs.

Dimensions
A:

    4-3/4 ”

B:

    4-3/4 ”

C:

    2-3/4 ”

Relamping/Maintenance

Disassemble faceplate. Clean dirt and deposits from

the luminaire and glass using only solvent-free

cleaners. Relamp and replace gasket if damaged.

Reassemble faceplate.

Lamp:

   3.0W LED 24V DC

22 228

01/31/2019

Page 1 of 2

Description

Faceplate

Gasket

LED Driver (24V DC)

LED Module (3000K)

LED Module (4000K)

Part No

FP2228

831032

75928

74038

74043

Notice to Installer for 22 228:

1. No relamping required.

2. In conformance with UL Standard 1598, a silicone based sealant must be used    

    between fixture and supporting wall.

3. 

Requires a 24V DC class 2 electronic power supply to operate intended LED  

    wattage.

22 228 Installation:

1. Loosen the (3) M4 socket head screws on the luminaire top and remove top from  

    the luminaire base.

2. Loosen the (2) M4 socket head screws on the base to remove the electrical plate  

    from the base. However, keep the luminaire wiring routed through the wireway of  

    the luminaire base.

3. Attach the adaptor ring from the mounting kit to a 3-1/2” or 4” octagonal wiring box  

    using the (2) wiring box screws.

4. Make supply wiring and luminaire wiring connections inside the wiring box.

 

NEGATIVE SUPPLY WIRE TO BLACK LUMINAIRE WIRE

 

POSITIVE SUPPLY WIRE TO RED LUMINAIRE WIRE

5. Test to make sure the luminaire base will be level when installed by aligning the  

    mounting holes on the luminaire base with the holes in the adaptor ring. Adjust the    

    adaptor ring if needed.

6. Place a small bead of silicone around the back side of the luminaire flange that will  

    come in contact with the finished wall (exterior applications only).

7. Secure the luminaire base to the adaptor ring and finished wall by using the (2)  

    countersunk screws provided.

8. Replace electrical plate.

9. Replace luminaire top and tighten screws evenly

mounting

plate or

luminaire

base

adapter

plate

wiring

box

screws

3-1/2” or 4”

standard

octagonal

wiring box

(by others)

mounting screws

Remote 25W LED driver and box 

19 580

Remote 50W LED driver and box 

19 591

Reviews: