Beem B19.001, User Manual

Page: 23 / 78

21
EN Pro-Multi-Grill 3 in 1 V2
BEEM - Elements of Lifestyle
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
Place the appliance on a level, heat ■
resistant surface that is also resistant
to splashing fat.
The surface finishes on furniture may
■
contain substances that can be detri-
mental to the rubber feet of the appli-
ance. If necessary, place a mat under
the feet of the appliance.
Do not place the appliance in a hot,
■
wet or very humid environment or in
the vicinity of inflammable materials.
There must be a gap of at least 15 cm
between the appliance and any walls,
furniture or other objects.
Select a location that does not allow
■
children to reach the hot surfaces of
the appliance.
The mains socket must be easily ac-
■
cessible and allow fast disconnection
in the event of an emergency.
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
Before connecting the appliance, ■
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
The mains socket must be protected
■
by at least a 10 A automatic circuit
breaker.
Ensure that the mains lead is undam-
■
aged and is not laid over sharp edges.
The mains cable must not be pulled
■
tightly, bent or come into contact with
hot surfaces.
Route the cable to prevent risk of trip-
■
ping.
If the appliance is to be connected
■
to the power supply via an extension
lead, the cable cross-section must be
at least 1.5 mm².
The electrical safety of the appliance
■
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.