Beem 09673, Manual

Page: 20 / 56

EN 20
1. Take the lid (
1
) off the milk jug (
6
).
2. Depending on the programme, place the frothing spiral (
8
) or the stirring insert (
9
) on the
magnetic pin on the bottom of the milk jug (
Picture C
) (see the “Preparation and Opera-
tion” chapter – “Programme Selection”).
3. Fill the milk jug with the appropriate amount of milk depending on the programme. Note
the maximum fi ll levels (see the “Preparation and Operation” chapter – “Markings in the
Milk Jug”).
4. Place the lid on the milk jug and press it down as far as it will go.
5. Place the fi lled milk jug into the base station (
3
).
6. Set the programme you want by pressing the On / Off button (
4
). The LED ring (
5
) indi-
cates the selected programme by fl ashing in the corresponding colour (see the “Preparation
and Operation” chapter – “Programme Selection”).
The programme then starts automatically. During the programme sequence, the LED ring
lights up constantly in the colour of the set programme
.
At the end of the programme you will hear eight beeps and the LED ring goes out. The
device then switches off automatically and the LED ring goes out.
The programme sequence can be aborted at any time by pressing the On / Off button for
a long time. The LED ring goes out and a beep is heard. The device switches off.
7. Pull the mains plug out of the plug socket after use.
Cleaning and Care
PLEASE NOTE!
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These may damage the surface.
• Check the connecting cable regularly for any damage.
1. If necessary, empty the milk jug (
6
).
2. Wipe down the base station (
3
) with a damp cloth. If necessary, use a little detergent to
remove more intense soiling.
3. Clean the milk jug and the lid (
1
) with warm water and detergent or in the dishwasher.
Please Note:
However, regular cleaning in the dishwasher may have a detrimental effect
on fi ttings. We therefore recommend cleaning by hand.
IMPORTANT!
The frothing spiral (
8
) and the stirring insert (
9
) must
not
be cleaned in
the dishwasher! Only rinse them by hand. For more thorough cleaning of the frothing spiral,
you can remove the ring.
4. Dry all parts well before you reassemble and / or store away the device.