27
EN
Not shown:
•
Operating instructions
•
Tea strainer (in teapot)
•
Limescale
fi
lter (in the water reservoir)
•
Heating element (attached at the foot of the water reservoir)
Before Initial Use
NOTES
•
Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a
fl
at, solid and heat-resistant surface that is
resistant to splashing.
•
Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
•
The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
•
There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device thoroughly before you
fi
rst use it (see
the “Cleaning and Care" chapter).
1. Clean the device and all accessories thoroughly (see the “Cleaning and Care” chapter).
2. Screw the lever (
12
) onto the discharge tap (
11
):
–
place the lever on the discharge tap (
Picture B1
),
–
press down lightly and
–
tighten the screw cap clockwise (
Picture B2
).
Do not over-tighten
the screw cap!
Two to three turns is enough to attach the lever.
3. Fully unwind the mains cable.
4. Place the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
5. Ensure that the On / Off switch (
9
) on the bottom side of the base (
7
) is in Position
0
(off). The operating lamp must not be lit.
6. Insert the mains plug into a properly installed plug socket that is easily accessible.
7. Before you
fi
rst enjoy tea or hot instant beverages, we recommend that you carry
out a trial run to remove any possible production residues. To do this, follow the
instructions in the “Operation” and “Preparation” chapters.
