Quick Start Guide - Argos 3D - P32X
Last change: 20 February 2017
Version 4
© Bluetechnix 2017
Page 7 | 13
1.4.1
Connecting the power supply
To ensure, that your Argos3D–P32X works correctly, connect the ‘Argos3D’ to a
12-30V DC
power supply
using connector
(a)
and wait for approximately 20 seconds until the camera boots up.
Pin assignment on the power connector (a): Pin #1: +12V to +30V, Pin#2: GND
Note
The power supply connector is protected against wrong polarity but the ‘Argos3D’ will not
work in case you don’t use the correct polarity! If the Argos3D–P32X doesn’t work please
check the power supply polarity first!
1.4.2
Connecting the Ethernet Cable
Plug in the Ethernet cable
(b)
and connect your Argos3D–P32X to your PC.
Figure 1-3: Argos3D–P32X with connected power supply and Ethernet cable
