Calibration Failure Messages
Introduction
Reagent Load/Calibration
UniCel DxC Systems Instructions For Use A13914
Page 5-20
October 2005
Calibration Failure Messages
Introduction
If there is a failure during calibration, for modular chemistry (MC) or cartridge
chemistry (CC), there is a pop-up message which shows:
• The chemistry that failed and
• The associated error code(s).
After a failure message, the operator can:
• Stop the calibration or
• Continue the calibration.
CC Subsystem Calibration Failure
The CC subsystem warns the operator of a failed calibration. If a chemistry fails, there
is a pop-up message after a completed calibrator level. The message includes:
• Calibrator name
• Chem name
• Reagent Position
MC Subsystem Calibration Failure
The MC Subsystem warns the operator of a failed calibration. If a chemistry fails,
there is a pop-up message after a completed calibrator level. The message includes:
• Chem name
• Calibration error
• Calibrator Name and Level Number
NOTICE
Refer to
Troubleshooting Calibration and Result Errors
for
additional information on Calibration Error messages.
