Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 339 / 498

A13914AF
9-103
Maintenance
As-Needed/As-Required Maintenance
9
Clean the CC Sample Probe, Reagent Probes and Mixers
The following procedure describes the automated procedure to wash the CC sample and reagent
probes and mixers. This routine takes the system approximately 15 minutes.
IMPORTANT
The System does not autoprime in Maintenance mode. After completing a maintenance
procedure, or when a procedure is aborted, exit the Maintenance menu to resume autoprime and return
the system to
Standby .
Materials Required:
•
CCWA cartridge (PN 657133)
1
Load the CCWA cartridge onto the system.
•
Select:
—
Rgts/Cal
from the menu bar,
—
An empty chem position to load (CC side),
—
Load F1
. Scan Chemistry Wash Solution Cartridge (CCWA).
2
The Wash procedure is accessed, select:
•
Utils
from the menu bar,
•
2 Maintenance
,
•
2 Cartridge Chemistry Probe Cleaning
,
OR
Type
2
in the
Procedure No.
field and press
(
Enter
)
.
Follow all instructions on the screen.
3
To perform the procedure:
•
Select
Continue
.
OR
•
Select
Cancel
to exit this screen without performing the procedure.
IMPORTANT
If desired, you may exit this procedure at any time before it is completed. To exit select
STOP
on the instrument; wait for the system to finish processing. To return the system to Standby ,
select
Instr Cmd
from the menu bar, then select
1 Home
.
A pop-up message confirms that probe and mixer cleaning is complete.
•
Select
Close
to exit.
4
At the completion of this procedure, the Maintenance menu appears.