Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 155 / 498

A13914AF
4-23
Reagent Load/Calibration
Enzyme Validator
4
IMPORTANT
When you start to do a calibration on a fresh cartridge, you must complete it within 8 hours or
the within-lot calibration established will be less than optimal.
Enzyme Validator
Introduction
The Enzyme Validator option provides the ability to obtain IFCC/DGKCh (refer to Additional
Information below) equivalent answers for selective enzymes, or to obtain IFCC/DGKCh equivalent
answers for the non-IFCC/non-DGKCh formulation enzymes.
•
The Synchron Enzyme Validator set is a human serum, albumin-based value assigned material
and is used like a calibrator.
•
The feature can be turned on or off for applicable chemistries; the default is off.
•
The Enzyme Validator Kit includes diskettes which provide set points for the selective enzymes.
IMPORTANT
When the enzyme reagent is configured and loaded, and the Enzyme Validator feature turns
on, Enzyme Validator ID assignments and calibration requests can be performed in the same manner as
any calibrator.
1
Select
Rgts/Cal
from the menu bar.
2
Select
Options F6
.
3
Select
Enzyme Validator
.
4
Select a desired Configured Chemistry name from the pull-down menu.
5
Select
Add
to move the chosen Chemistry to the Selected Chemistries area.
6
Repeat Step 5 for other chemistries, if appropriate.
7
Select
OK
to enable the Enzyme Validator option.
OR
Select
Cancel
to exit without enabling the option.