Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 146 / 498

A13914AF
4-14
Reagent Load/Calibration
Calibration Status
1
Select
Rgts/Cal
from the menu bar.
2
Select
Assign F7
.
3
Use the down arrow option button to open list of calibrators.
4
Select the calibrator.
5
Enter the ID of the calibrator or the rack/position number.
•
If using a bar code label, the label must match the assigned calibrator ID.
•
If a rack/position is assigned, the calibrator must be placed in this assigned position.
6
Repeat Steps 3–5 to assign additional calibrators.
7
When calibration assignment is complete, select
Close
.
Calibration Status
Introduction
Calibration status, as well as reagent status, is accessed from the
Rgts/Cal
dialog box. Calibration
status is shown to determine which chemistries require calibration.
Calibration Status Messages
Table 4.2 Calibration Status Messages
Message Explanation
Requested Indicates that calibration is pending and calibrators have been identified.
Calibrated Indicates that the chemistry has been calibrated and has not exceeded its
calibration time period.
Cal Required Appears when:
• a new cartridge is loaded.
• a user-defined cartridge is loaded.
• a non-overrideable calibration failure has occurred.