Beckman Coulter Navios, Instructions For Use Manual

Page: 218 / 586

773232AH
10-22
Using Navios Software
Cytometer Toolbar
Once all alterations have been made, . The toolbar becomes active once all files have
been entered. A list of files for each panel is shown allowing you to choose the batch required to run
first.
The rest of the files follow in order after the selected panel.
Cytometer Toolbar
AutoMATOR Setup
Display the AutoMATOR Setup dialog box.
Stop
Cancel the batch run. This aborts the current panel. When the panel runs again,
the test starts from the beginning.
Run
Start the batch running. The AutoMATOR Status Bar appears showing the status
of the tests, that is, if it is currently paused, still running, and so on.
Pause
Pause has two states:
•
Continuous Pause
Pause the tests for modifications and remain on pause until you decide to
continue. This function allows the test to stop without reverting to the
beginning of the panel again. To resume the test, click the Pause button
again.
•
Auto Pause
The run of tests pauses and then carries on with the rest of the panel
automatically after a 15-second wait. The countdown is displayed on the
AutoMATOR Status Bar. When the tests are in the Auto Pause setting, you can
hold down
(
Shift
)
and click the Pause button.
(
Shift
)
overrides the Auto
Pause, placing the AutoMATOR into Continuous Pause. To restart, click the
Pause button again and the test resumes from the point at which it was
paused.
Restart Acquisition
Reset the current acquired events to zero and clear the
current data in memory. Acquisition restarts at zero
events and continues until a stop condition is reached.
Start/Continue Acquisition
(
(
F9
) )
Start acquisition or continue an acquisition if previously
paused.
Pause Acquisition ( (
F11
) ) Pause Acquisition of the current sample.