Beckman Coulter Microfuge 20 Series, Instructions For Use Manual

Page: 31 / 74

B30162AA 2-1
CHAPTER 2
Operation
Introduction
This section contains operating procedures for the centrifuge, using the rotor designed for use in these
centrifuges. Refer to the applicable rotor manual for instructions on preparing the rotor for centrifugation.
To prevent condensation, keep the centrifuge door closed and the power turned off
(
O
)
when the centrifuge
is not in use.
NOTE
If the centrifuge is used in a manner other than that specified in this manual, the safety and
performance of this equipment could be impaired.
WARNING
Normal operation may involve the use of solutions and test samples that are
pathogenic, toxic, or radioactive. Operator error or tube failure may generate
aerosols. Do not run potentially hazardous materials in this centrifuge unless all
appropriate safety precautions are taken. Always use the appropriate rotors and
adapters.
Handle all infectious samples according to good laboratory practices and methods
to prevent the spread of disease. Ask your laboratory safety officer to advise you
about the level of containment required for your application and about the proper
decontamination or sterilization procedures to follow if fluids escape from
containers. Biosafe containment should be used when Risk Group II materials (as
identified in the World Health Organization
Laboratory Biosafety Manual
) are
handled; materials of a higher group require more than one level of protection.
Because spills may generate aerosols, observe proper safety precautions
for aerosol containment.