Beckman Coulter CESI 8000, Preinstallation Manual

Page: 36 / 46

B11953AC 3-2
Preparing CESI 8000 for Setup
Upon Receiving the CESI 8000 System
Safety Considerations During Setup
When the Field Services Representative arrives to unbox and set up your unit, ensure the following
precaution is observed:
CAUTION
A minimum of four people is needed to lift the CESI 8000 instrument. Failure to do
so could result in bodily injury and/or damage to the instrument.
MS Setup
If you are using a Thermo Scientific MS, prior to installing the NanoSpray II source ensure that the
1-inch adapter ring for dynamic nano spray is not installed. See
Figure 3.1 . Follow the
manufacturer's instructions on how to remove this part.
Figure 3.1 Remove 1-inch Adapter Ring
Additionally, ensure the Ion Sweep Cone has been removed from the MS. See Figure 3.2 .
1. Socket Head Screws
2. Ion Max Adapter
1. 1-Inch (Deep) Adapter Ring