Configuration
EK9500
31
Version: 1.0.0
Network-Interface
The network interface enables you to set the IP address. Please note that the DIP switch of the EK9500
takes precedence and its setting applies regardless of what you set in the dialog
Fig. 24: Configuration via HTML pages - network interface
Example
DIP switch DIP 1 = on; DIP 2...10 off, setting in the dialog 10.1.2.3 -> genuine IP address = 10.1.2.1 (The
DIP switch overwrites the last byte of the IP address).
Set the desired IP address and then click on the checkmark.
Note: the old IP address is displayed again in the dialog field since it is still the valid address.
A software reboot is necessary after changing the IP address. To do this, go onto "Boot Opt." and click on
"Reboot".
With the DIP switch setting
• DIP 1 to DIP 8 = on and
• DIP 9 and DIP 10 = off
all 4 bytes of the IP address are accepted from the dialog field.
Firmware Update
Is not used at this time.
5.2
EtherCAT configuration
EtherCAT Terminals can be configured and parameterized via the HTML page Beckhoff Device Manager.
Summary of Contents for EK9500
Page 2: ......
