Beckhoff CP32-1600 Series, Manual, Page: 26 / 56

Commissioning
CP32xx-1600 26 Version: 1.0
Fig. 14: CP32xx-1600_orientation of the mounting arm adapter
To fasten the mounting arm adapter to the Panel PC, follow the steps below, shown in Fig. 15:
1. Remove the cover of the mounting arm adapter (section A). For the exact procedure, see chapter
3. Interface description [ } 11] .
2. Place the mounting arm adapter with the four M6 screws at a distance of 70 x 130 mm in front of the
corresponding four M6 threaded holes on the rear side of the Panel PC (section B).
A B
Fig. 15: CP32xx-1600_installing the mounting arm adapter
3. Tighten the four M6 screws with a tightening torque of 6 Nm.
4. Replace the cover on the mounting arm adapter.
ð
You have installed the mounting arm adapter on the Panel PC.
A strain relief plate is located inside the mounting arm adapter. You can relocate this according to your
requirements.
4.2.1 Dimensions
All dimensions are in mm.
Fig. 16 shows the dimensions of the 15.6-inch Panel PC.