Maintenance
C6030
37
Version: 2.7
7.2.3
Replacing the fan
NOTE
Incorrect fan type
The Industrial PC may be damaged if the wrong type of fan is installed.
• Only replace the fan with a replacement fan from Beckhoff Service.
The fan ensures optimum cooling of the Industrial PC. Order a replacement fan only from Beckhoff. To do
this, contact Beckhoff Service (see Chapter 10.1 Service and support).
To change the fan, follow the steps shown in Fig. 23:
1. Remove the two logo strips on the top and bottom of the Industrial PC (section A). You can obtain
replacement strips from your Beckhoff Service (see Chapter 10.1, Service and Support).
2. Remove the four Torx TX10 screws at the top and bottom of the PC (section B).
3. Remove the fan housing (section C).
4. Remove the two Torx screws to detach the fan from the fan plate (section D).
D
A
B
C
Fig. 23: C6030_Fan access
5. Disconnect the fan power cable from the motherboard and pull it out of the cable sleeve.
ð
You can now replace the fan.
6. Pull the supply cable of the new fan through the cable sleeve and plug it into the motherboard.
7. Attach the fan to the fan plate with the two Torx screws and a tightening torque of approx. 0.5 Nm.
ð
You have successfully replaced the fan.
The old fan must be disposed of in accordance with the national electronic waste regulations.
