Beckhoff C6025, Manual

Page: 22 / 45

Commissioning
C6025 22 Version: 1.8
4.2.3 Installation in the control cabinet
NOTE
Extreme environmental conditions
Extreme environmental conditions can cause damage to the device.
• Avoid extreme environmental conditions.
• Protect the device against dust, moisture and heat.
• Do not block the ventilation slits of the device.
When installing in the control cabinet, make sure that there is 5 cm free space above and below the device
for air circulation and for opening the PC.
Mounting via mounting plates
In order to mount the Industrial PC with mounting plate 1 or 2 in the control cabinet, it must be furnished with
the holes for the fastening screws according to the dimensions of the PC (see Chapter 4.2.2
Dimensions
[
}
20] ). You need M4 screws for mounting.
After you have drilled the holes for the fastening screws in the control cabinet, you can mount the Industrial
PC in the control cabinet with mounting plates 1 or 2.
Fig. 14: C6025 _Mounting plates for control cabinet installation
To install the Industrial PC in the control cabinet, follow the steps below:
1. Place the fastening screws in the drill holes in the rear panel of the control cabinet.
2. Hang the PC onto the screws at the marked points on the mounting plate (see Fig.14).
3. Tighten the fastening screws.
ð
You have successfully installed the Industrial PC in the control cabinet.
Mounting via DIN rail adapter
If you want to install the Industrial PC in the control cabinet via the DIN rail adapter, no preparation of the
control cabinet is necessary. All you need to do is attach the device to the DIN rail using the adapter. To do
this, follow the steps shown in Fig. 15: