4.11
RS232 interface, PC connection (X8), master only
The setting of the operating, position control, and motion-block parameters, can be car-
ried out by using the setup software on an ordinary commercial PC.
Connect the PC interface (X8) of the servo amplifier
while the supply to the equipment
is switched off
via a null-modem cable to a serial interface on the PC
(do not use a
null-modem link cable!)
.
The interface has the same potential as the internal logic, and uses AGND as the ground
reference.
The interface is selected and set up in the setup software.
Further notes can be found on page 34 .
Interface cable between the PC and servo amplifiers of the AX2500 series:
(View: front view of the built-in SubD connectors, this corresponds to looking at the solder
side of the SubD connector on the cable.)
56
AX2500 Installation Manual
Interfaces
02/06
Beckhoff
AX2500
Summary of Contents for AX2500 Series
Page 31: ...3 4 4 Connector assignments AX2500 Installation Manual 31 Beckhoff 02 06 Installation...
Page 65: ...5 3 2 3 Status display on the master AX2500 Installation Manual 65 Beckhoff 02 06 Setup...
Page 68: ...This page has been deliberately left blank 68 AX2500 Installation Manual Setup 02 06 Beckhoff...
