Mechanical installation
92
───
Version: 4.3
AM8000 and AM8500
8.3
Fan cover [+]
A motor is cooled by an external device using forced ventilation.
This facilitates higher performance. The air flow passes through the
fan cover [+] over the motor housing.
8.3.1
Mounting
Clean the working environment
Workplaces and their immediate surroundings must be tidy and
dust-free. Avoid dirt in tapped holes.
Non-observance can result in damage and malfunction of the com-
ponents.
► Attach the motor to the machine
Only for the AM807x series:
► If necessary, loosen and remove the eyebolts on the motor
housing
1
2
3
► Push the fan cover [+] [1] onto the housing up to the mechanical
stop
► Make sure that on both sides of the motor the elongated holes
[3] are aligned with the screw connection devices [2]
4+5
6+7
8
11
9
10
► Fit screws [4] to [7]
► Fit nuts [8] and [11] with washers [9] and [10]
► Observe tightening torques:
Screws
Nuts
3 Nm size 2.5
2.5 Nm, size 7
Use Beckhoff control cable
Use the pre-assembled control cable ZK4054-6400-0xxx to connect
the fan cover [+]
12
13
► Plug the power connector [12] into the power box [13] of the mo-
tor
► Hand-tighten power connector [12] and check for tight fit
Summary of Contents for AM8000 Series
Page 1: ...Operation Instructions EN AM8000 and AM8500 Synchronous Servomotors 8 27 2020 Version 4 3 ...
Page 2: ......
Page 122: ......
