GT6201
_________________________________________________________________________________________
DV 17001.03 Issue 4 01/2015
Page 39
3. Press the “ROTARY ENCODER“ once again to select the 25/8.33 kHz digits. Then rotate the
“ROTARY ENCODER” clockwise/counter clockwise to change the frequency.
Each short press on the “↨/SCN” key interchanges the active and preset frequency.
Note:
While the transceiver is in transmission mode, this
toggle function is disabled.
Press the “STO” key to store the active frequency into the next vacant memory place in the user
channels database.
3.5.2
Direct Tune Mode
Press the “MDE” key until the direct tune mode page appears.
Note:
If BATTERY VOLTAGE in the installation setup is deselected, this mode
is not accessible! Only standard or channel mode are accessible
.
In direct tune mode the active frequency is indicated in the top line. It can be edited by means of
the “ROTARY ENCODER” following the procedure. The battery voltage, indicated in the bottom
line shows the current value of the supply voltage.
To change the active frequency when in direct tune mode;
1. Press the “ROTARY ENCODER“ to select the 100 MHz digits. Then rotate the “ROTARY
ENCODER” clockwise/counter clockwise to change the frequency.
2. Press the “ROTARY ENCODER“, again to select the 100 kHz digits. Then rotate the “ROTARY
ENCODER” clockwise/counter clockwise to change the frequency.