Becker E16-V1, Assembly And Operating Instructions Manual

Page: 13 / 24

Use the travel button to run the bolt in the open direction until it is engaged by the bolt
mechanism.
▻ The tubular drive switches off automatically.
Use the travel button to run the bolt in the down direction and disengage it from the
bolt mechanism, then stop the tubular drive. Then press the programming button.
▻ The unlocking limit position is now saved and the tubular drive makes a
"click" sound to confirm.
►
Limit positioning is now complete.
The sun protection system will now lock and unlock automatically in the lower limit
position when you close and open it.
Deleting the limit positions using the programming unit
Connect the wires of the tubular drive to those of the same colour in the programming unit
and switch on the power supply.
Please pause for 1 sec after the last drive command before beginning the deletion se-
quence. Also leave a pause of 1 sec between the individual steps of the deletion sequence.
black
brown
blue
green-yellow
black
brown
blue
green-yellow
Programming button Travel button
Press the programming button and keep it pressed.
Then press down the travel button and keep it pressed.
Now release the programming button, but continue to keep the travel button pressed.
Next press the programming button again.
▻ The tubular drive acknowledges.
► Both limit positions are deleted.
13