Becker Centronic SunWindControl SWC510, Assembly And Operating Instructions Manual

Page: 28 / 60

What to do if...?
Problem Remedy
The drive is not functioning. Check connection.
The drive is running in the wrong dir-
ection. Swap wires and on the sensor.
The sensor does not perform the
manual drive commands from a
hand-held transmitter. Program transmitter.
Automatic drive commands are not
executed. Program transmitter.
Set the slide switch of the hand-held/
wall transmitter to “ ”.
System does not extend automatic-
ally when slide switch is set to “ ”. Adjust the sun threshold on the
transmitter.
Wait for the wind to die down.
System does not extend manually
when slide switch is set to “ ” or “ ”.
Wait for the wind to die down.
Simplified EU declaration of
conformity
Becker-Antriebe GmbH hereby declares that this radio control system com-
plies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
web address:
www.becker-antriebe.com/ce
Subject to technical changes without notice.
28 - en