Programming more transmitters
The receiver mode must always be set appropriately for the
receiver. Roller shutter/venetian blind is the factory setting.
Programming more B-Tronic transmitters in the B-
Tronic receiver
Put the receiver into programming mode in one of the three possible ways.
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Putting the B-Tronic receiver into programming mode with a pro-
grammed B‑Tronic transmitter
Put the transmitter into master mode.
Select the receiver by pressing the button until the desired receiver con-
firms.
All the following settings will then only be executed for this device.
Press the programming button of the pro-
grammed transmitter.
▻
The receiver confirms.
►
The receiver goes into the programming
mode for 3 minutes
Putting the B-Tronic receiver into program-
ming mode by switching on the power
Switch on the power.
►
The receiver goes into the programming
mode for 3 minutes
12
