Becker 0622.834-923, Installation And Operation Manual

Page: 31 / 52

Operating Instructions
Frequency Selection Modes
DV16800.03 Issue 03 08/2015 GK61X-XX 31
3.4.2. Direct Tune Mode
Press the "MDE" key until the direct tune mode page appears.
IC
SQL
118.005
BAT 15.5V
Note: The battery information is only displayed if BATTERY VOLTAGE in the
installation setup is selected.
In direct tune mode, the active frequency appears in the top line. It can be edited by means of the
"ROTARY ENCODER" following the procedure.
Changing the active frequency when in direct tune mode:
• Make a "short press" on the "ROTARY ENCODER" for modification of the 100 MHz digits.
Rotate the "ROTARY ENCODER" clockwise/counter clockwise to change the frequency in
1 MHz steps.
IC
SQL
118 .005
• Make another "short press" on the "ROTARY ENCODER" for modification of the 100 kHz
digits.
Rotate the "ROTARY ENCODER" clockwise/counter clockwise to change the frequency in
100 kHz steps.
IC
SQL
118. 0 05
• Make another "short press" on the "ROTARY ENCODER" for modification of the
25/8.33 kHz digits.
Rotate the "ROTARY ENCODER" clockwise/counter clockwise to change the frequency in
25/8.33 kHz steps.
IC
SQL
118.0 05
Notes:
The changes become active immediately
Changing the active frequency is possible only when the transceiver is not transmitting.
If wanted, please press now the "STO" key to store the active frequency into the next vacant memory
place of the user channels database.