www.beast-tek.com
Microbe Build Guide
Page 16
26. Install the nine leds. The eight 3mm leds are all oriented the same direction. Orientation is shown in
the diagram below. Remember the shorter lead is negative and the longer lead is positive.
27. Peel the protective coating from the clear acrylic sheet. Place the front panel on top of the clear
acrylic panel. Now place over the jacks and pots and wiggle things into place so the panel sits nicely.
DON’T put any nuts on the jacks or pots yet. First push the big 10mm LED via its leads through the panel.
Next work through the eight 3mm leds pushing them through one by one so they are flush with the
panel. If you put any nuts on the jacks or pots, you will need to remove them so that the LEDs can be
pushed through the panel without issue. Once all LEDs and pushed through and sitting nicely in the
panel, install one jack nut and finger tighten it to hold the panel loosely in place.
