BEARWARE 304273, Manual

Page: 27 / 72

27
English
Atmospheric pressure
The atmospheric pressure is automatically measured every hour and shown in
the display. The table shows the approximate trend of the atmospheric pressure.
10. Additional settings
DCF signal
The base station synchronises the internal clock every night with the DCF signal. To
receive the DCF signal manually, press and hold the "DOWN" button for 3 seconds,
until the following symbol appears in the display and flashes: “ ”.
When the signal is received successfully, the symbol will glow continuously. If the
signal is not received, the symbol disappears again.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice a minute, which is automatically received
by the base station. You can also manually enable the signal reception. To do this,
press and hold the "CHANNEL" button for about 3 seconds until the channel sym -
bol (" ") starts flashing. Once the signal has been successfully received, the
animation of the symbol disappears and the received temperature and humidity
is shown on the display of the weather station.
Switching the keypad tones on and off
Press the "UP" button in the default screen for about 3 seconds to turn the
keypad tones off. The entry is confirmed with a beep.
Caution!
11. Safety instructions and disclaimer
Never try to open the device to repair or make modifications. Avoid contact with
the mains voltage. Do not short-circuit the product. The device is not waterproof,
hence please use it only in dry surroundings. Protect it from high humidity, water
and snow. Keep the device away from high temperatures.