Bearcat BC-502/CRC, Instruction Manual

Page: 48 / 164

BC-502/CRC
48
WARNING: IF THE MASTER SWITCH AND ANY SECTION SWITCH IS
TURNED ON WHEN LOWERING A WING, THE WING WILL
TURN ON (SPRAY). THIS COULD RESULT IN SEVERE
BURNS, SERIOUS INJURY OR DEATH.
WARNING: MAKE SURE ALL PERSONNEL ARE CLEAR OF THE REAR
AREA OF THE TRUCK WHEN THE WINGS OR THE SPRAY BAR ARE
ACTUATED. FAILURE TO KEEP A SAFE DISTANCE COULD
RESULT IN SERIOUS INJURY OR DEATH.
Spray Valve Switches
Left Wing
Dedicated spray valve control sections on left wing. (One switch per
section)
Main Bar
Dedicated spray valve control sections on main 8ft center spray bar. (One
switch per section)
Right Wing
Dedicated spray valve control sections on right wing. (One switch per
section)
NOTE: The standard “section” or “cut” is 3 nozzles (1 foot). Optional 2 foot
sections or cuts have been produced controlling 6 nozzles.
L. Marker & R. Marker
MAST – turns on single spray nozzle at extreme end of spray bar with the
spray bar “Master” switch. ON – (Momentary) turns on single spray
nozzle at extreme end of spray bar independent of “Master” switch.
Master
This switch turns on or off any sections of the main bar and left and right
wings, that have been selected with both the dedicated spray valve
controls and the Taper Cut. The ready position changes circulate speed to
match proper pump output for spread rate x spread width x starting
speed (Ready Set Point).