41
Clean the Equipment
Keep the unit clean. A dirty unit cannot be monitored for
safety as well as a clean unit.
•
ALWAYS check the following components for
wear or defects after the first week of
operation, and monthly thereafter:
1.
Tank-mounting tie-downs
2.
Fasteners
3.
King plate fasteners (if used)
4.
Suspension components
5.
Running gear components.
Safety Decals and Plates
All safety decals and plates must be clean, legible and
in good condition.
•
Always clean any safety decal or plate that becomes dirty.
•
Always check the condition of safety decals and
plates before each use.
•
Always replace any safety decal that is illegible
through wear and tear or is peeling off the
equipment.
•
Never operate the equipment with a safety decal
or plate that is hard to read or is missing.
•
The following diagram shows the location and part numbers
of all safety decals.
•
Please contact BearCat for replacement decals at:
Phone: (928) 684-7851
Summary of Contents for BC-502/CRC
