When a menu function is selected, the display will show immediately the first available option for the
selected menu function. To select a menu item, press
<ENTER>.
Press the <MENU> button repeatedly until you reach the desired menu function. Use the <UP> and
<DOWN> buttons to navigate the menu options. Press the <ENTER> button to select the menu function
currently displayed or to enable a menu option. To return to the previous option or menu without
changing the value, press the <MENU> button.
NO alterative worth that return re-option or menu, press(MENU)button.
4.2 Menu map
A001 (Address code setting from A001—A512)
AU01 (auto-moving speediness)
AU02 (slow speed auto-moving)
SNOF (off Sound control)
SNON (on Sound control)
RPOF (Set pan to non-inverting)
RPON (Setting pan circumrotate reverse)
RTOF (Set tilt to non-inverting)
RTON (Setting tilt circumrotate reverse)
RDON (Set the LED readout to inverting)
RDOF (Set the LED readout to non-inverting)
DFON (Factory default on)
DFOF (Factory default off)
RST (Reset)
Note, output default setting address code is A001, pan is positive circumrotate. tilt is positive
circumrotate. LED positively reveal.
4.3 User configurations
Setup single-desk light's auto moving mode(self-motion move)
•
Press the MENU until it shows AU01
•
Use the UP/DOWN buttons to set to AU01 or AU02 ,Press ENTER to confirm.
Setup single-desk light's auto moving mode(sound control)
•
Press the Mode button unlill it shows SNOF
•
Use the UP/DOWN buttons to set to SNOF.press ENTER to confirm.
Master/stave mode(auto-running. sound control)
•
This mode will allow you to link up 32 units together without a controller.
•
Use standard DMX cables to daisy chain your until together via the DMX connector on the rear of
the units. Proper performance it may be necessary to use a terminator at the last fixture.
•
Choose a unit to function as the Master. Select NAFA / NASL OR NStS (see below for readout)
depending upon which master mode your require. The master until must be the first unit in line.
Finally chain the units together using DMX cable.
To set the pan to inverting
•
Press the MENU until it shows RPOF.
•
Use the UP/DOWN buttons shows RPON, press ENTER to confirm.
To set the tilt to inverting
•
Press the MENU until it shows RTOF
•
Use the UP/DOWN buttons shows RTON. press ENTER to confirm.
