If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Press
off existing modes. Press
return the last modes.
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press
on the remote controller.
2. Press
or
to choose between the different auto programs.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
3. Press
again to turn off the strobe.
To adjust the speed of the automatic program and the sound active program.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
To enable DMX or disallow DMX on the product.
Press
on the remote controller, the product work on the DMX controlling modes.
1. Press
on the remote controller.
2. Press
,
,
,
,
, (red, green, blue, white or amber) to choose your colour.
3. Press again
,
,
,
,
, (red, green, blue, white or amber) to close your colour.
4. Press
or
to either increase or decrease the percentage of each colour.
To adjust the FADE speed of the automatic program, the sound active program and the manual mode.
1. Press
on the remote controller.
2. Press
again to turn off the fade mode.
To adjust the brightness value of the automatic program, the Sound active program and Manual Mode.
Press digit
to
to change different brightness on the device.
Summary of Contents for 150.796 V1.0
Page 1: ...BWA530 PAR 150 796 V1 0...
