Whip Dual Mode Antenna
RST706B
Installation Manual
BEAM Communications Pty L
td
Iridium Beam Whip Dual Mode Antenna
Kit Contents
1. Antenna
2. Lock Washer
3. Lock Nut
4. 5m Cable Set
PAR
T #: USRMAN007602
BEAM Communications Pty Ltd
5/8 Anzed Court, Mulgrave
Victoria, 3170, AUSTRALIA
Tel: +61 3 8588 4500
Fax: +61 3 9560 9055
Info: [email protected]
Support: [email protected]
www.beamcommunications.com
1
4
2
3
Introduction
The Iridium Beam Whip Dual Mode Antenna
(RST706B) is intended for Land based
applications. Designed to work with Beam
Iridium products and other Iridium based devices.
Iridium Whip Dual Mode Antennas (RST706B)
excel in SUV/4WD/RV and Truck applications
where a rugged antenna giving the highest
possible clearance above the roof line is
required. The antenna can be easily fitted to
the bull bar of a vehicle and has 5 meters (16 ft)
of cable included.
This device complies with Part 15 of the FCC
Rules. Operation
is subject to the following
two conditions:
(1) this device may not cause harmful
interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Antenna Installation Location
The antenna should be attached in a location
that provides the clearest line of site to the
sky without obstruction or interference. Ideally
the antenna should be fitted on the bull bar of
a vehicle. Most bull bars already have a fitting
and hole for this type of antenna, if not, then a
suitable hole or fixing plate will be required.
Important Safety Information
WARNING
Changes or modifications not expressly approved by
Beam Communications could void the users authority
to operate the equipment or the warranty.
