
4
USER MANUAL
MAINTENANCE
SPECIFICATIONS
TO LOWER THE VEHICLE (see Fig. 1, 2)
1. Raise the jack slightly and pull back on the Height Lock Release to release Height Lock Bar (2).
2. Fasten the High lock release (11) to the Clip.
3. Press the Release Pedal (19) very gently to lower the Saddle (7) and vehicle.
(See Fig. 1)
TO ADD HYDRAULIC JACK OIL
With lift saddles fully lowered and the jack on level ground, unscrew and remove hydraulic ram. Using a
good grade of SAE 5 W hydraulic jack oil, fill the oil reservoir to the bottom of the threads in the oil filler
hole. Replace and tighten the hydraulic ram. DO NOT ALLOW dirt or debris to enter the system.
TO REPLACE HYDRAULIC JACK OIL
• Open the release valve by pressing down on the release pedal (19). Unscrew and remove hydraulic ram.
• Turn entire jack over so that all of the old oil will drain out of the oil fill hole.
NOTE:
When draining oil, use a proper container and ALWAYS follow ALL local and state waste disposal
guidelines.
• After all of the old oil has drained out of the jack, turn the jack back over to a level position to fill with
new oil.
• Rapidly pump foot pedal (18), 6 to 8 full strokes to release any pressurized air.
• Using a good grade of SAE 5W hydraulic jack oil, fill the reservoir to the bottom of the threads in the oil
fill hole. DO NOT ALLOW dirt and debris to enter the System
• Replace and tighten.
IMPORTANT:
When adding or replacing oil, ALWAYS use a good grade of (SAE 5 W) hydraulic jack oil.
NEVER use brake fluid, alcohol, glycerin, detergent motor oil or dirty oil of any kind. Improper oil usage
will cause serious internal damage to jack.
LUBRICATION
• Use a good grade of lubricating oil on all moving parts when needed.
STORING
• When jack is not in use, or when storing the jack, ALWAYS have the lift saddles in the lowest (down)
position.
RUST PREVENTION
Check power unit (hydraulic ram) see parts list Fig. 1 number (20) page 3, every two months or sooner
based on use for any rust or corrosion. Clean and wipe down with oil cloth.
Maximum load capacity:
680 kg.
Locking Positions:
20, 28 and 33 cm.
Measurements:
79 x 37 x 33 cm.
Weight without straps and extensions (sold separately): 26.8 kg.