BDCOM S3756F Hardware Installation Manual
- 15 -
4
Sending/receiving the normal phase of data 2
TP2+
5
Sending/receiving the paraphase of the data 2
TP2-
6
Sending/receiving the paraphase of the data 1
TP1-
7
Sending/receiving the normal phase of data 3
TP3+
8
Sending/receiving the paraphase of the data 3
TP3-
3.3.4 Connecting Gigabit SFP Ports
BDCOM S3756F provides 48 gigabit SFP ports. G1-G4 ports are combo ports. You can
connect the SFP optical module to the SFP port and then you can connect other Ethernet terminal
devices through the optical cable.
Figure 3-9 Connecting the gigabit SFP port and other Ethernet terminals
1.4 Checking after Installation
Before electrically starting up the switch, perform the following checkups after the switch is
installed:
If the switch is installed on the cabinet, check whether the installation point between
the cabinet and the switch is strong. If the switch is installed on the desk, check
whether there is enough space for the switch to discharge its heat and whether the
desk is stable.
