MAINTENANCE
65PT
Pull-Type Compost Topdresser
INSTRUCTIONS
IMPORTANT SAFETY PRECAUTIONS
CAUTION!!!
O
Operator must read before using unit.
1
KEEP HANDS AWAY from any moving parts of the
spreader during operations.
2
NEVER run spreader unless all guards are
securely tightened in proper position.
3
NEVER repair any parts or make any adjustments
while machine is in motion.
4
NEVER wear loose clothing around any moving
parts of the machine.
5
NEVER allow anyone to ride spreader.
6
NEVER operate on slopes.
!
!
!
!
Failure to heed the above warnings may result in
personal injury or death.
1
The Model 65PT
has a very simple design, with
maintenance-free, sealed bearings in all but three places -
the wheel bearings. These bearings will require lubrication
every 10 hours. Grease zerks are located on the right
wheel hub and below the axle on both sides of the unit.
Maintenance Interval
-
with each use.
2
Always check
tire pressure before using the 65PT.
3
Store the 65PT Topdresser Inside
for extended service
life.
4
Pressure wash
the
conveyor rollers
weekly through the
four round holes to
insure longer life of
the conveyor belt.
5
to Adjust Conveyor Belt Tightness
, loosen,
but DO
NOT REMOVE,
the 4 nuts on the slide tighteners on
both sides. Using a ¾
O
wrench, tighten the adjusting nut
until there is ½
O
to ¾
O
play in the center of the conveyor
belt. Always measure each side so the adjustment is
equal on both sides.
6
The End Gate is
Adjustable
for
different material
flow rates by simply
using the gate
adjuster handle at
the right front of the
unit. Pull the pin out,
turn the handle to set
the endgate at the
proper height, and
replace the pin.
3
