Chapter 6: Optional Docking Station and Printer
6-6
Clinician’s Operation Manual
Release printer door by lifting clear cover.
1.
Loading Paper
The printer uses 58mm wide thermal paper. See
Chapter 10
:
Optional Supplies & Accessories
for part
number and ordering information. To load the paper, follow the steps illustrated below.
Swing open paper holder by
2.
continuing to pull on clear door.
Remove existing spool if present.
3.
Place paper spool in holder so that
4.
the paper exits over the top of the
roll and drapes over the rubber
roller as shown in figure 6-6C.
Figure 6-6A: Release Printer Door
Lift here
Figure 6-6B: Swing Open Paper Holder
Figure 6-6C: Place Paper Spool in Holder
Close the paper holder door and the clear
5.
cover.
Tear off any excess paper by pulling the
6.
paper up toward the front of the printer.
The printer is now ready to use.
7.
Figure 6-6D: Close Paper Holder Door and Clear Cover
Summary of Contents for 10
Page 2: ......
Page 6: ...Table of Contents iv Clinician s Operation Manual This page is intentionally left blank ...
Page 81: ......
