12
WWW.BBTA.COM.AU
BBT-BC-26CCBH, BBT-BC-26CCDH, BBT-BC-52CCBH
Line head rotates in a CLOCKWISE direction. The CUT-
OFF KNIFE will be on the right side of the debris shield.
Cutting with a Nylon Head
RULES OF SAFE OPERATION
For nearly all cutting, it is good to tilt the line head
so that contact is made on the part of the line circle
where the line is moving AWAY from you and the
debris shield. (See appropriate picture). This results in
the debris being thrown AWAY from you.
The proper debris shield must be in place on the
unit when nylon cutting line is used. The cutting
line can flap around if too much line is exposed.
Always use the plastic debris shield with cut-off
knife when using nylon cutting heads.
WARNING
Tilting the head to the wrong side will shoot the
debris TOWARDS you. If the line head is held flat
to the ground so that cutting occurs on the whole
line circle, debris will be THROWN at you, drag
will slow the engine down, and you will use up a
lot of line.
WARNING
Use only quality nylon monofilament line of
2.5mm diameter.
NEVER use wire or wire-reinforced line in place of
nylon trimmer line. Load your nylon line cutting
head only with nylon trimmer line of the proper
diameter.
WARNING
Use extreme caution when operating over bare
spots and gravel, because the line can throw small
rock particles at high speeds.
Debris shields on the unit cannot stop objects
which bounce or ricochet off hard surfaces.
WARNING
