Microseparator™ Coolant Systems Transport, Installation, & Initial Startup
M000005_A - V Twin Ultra Transport & Installation 5.2-EN TM
20/78
10.3
Pump Station/Pump Station Low Profile
When removing the Pump Station or Pump Station Low Profile from the
pallet, ensure that the fork tangs pass fully beneath the assembly as
shown in the photo below. Lift only from the side of the assembly.
Damage can result to the interior section of the Pump Station if forklift
tangs are not positioned as shown.
Pump Station Low Profiles are often shipped with 2 on a pallet. If this is
the case, be sure to remove any wood pieces running through both units
before attempting to lift the Pump Station Low Profile.
Figure 10 - Lifting Pump Station