CAUTION: You must install the new memory module into the
appropriate location to assure proper operation. You may only
have one type of memory module installed.
5.
Remove the four nuts on the appropriate location with the nut
driver or socket and place the nuts in a safe place.
6.
Install the new memory module into the appropriate location by
matching the four holes on the module with the bolts on the
bottom panel. The ribbon cable should face away from the
LEDs on the front panel. Secure the memory module in place
with the four nuts by tightening them with the nut driver or
socket.
7.
Plug the ribbon cable onto the appropriate J-connector on the
main board.
8.
If you need to install any additional memory onto the memory
module, please refer to
Appendix C.1
for the M24SII-M01
memory module or
Appendix C.2
for the M24SII-M02 memory
module. If not, replace the top panel. The installation is now
complete.
Summary of Contents for 24SII
