![background image](http://html1.mh-extra.com/html/bayrol/naturally-salt-salt-relax-power/naturally-salt-salt-relax-power_operating-and-installation-manual_2713062033.webp)
6 Redox option
33
NOTE!
Check the redox setpoint at least every 2 months.
Always check the redox setpoint if you add care products (e.g. flocculants, algicides…) to your pool water.
The redox value may change although the chlorine value remains stable.
6.4.2
Setting the redox setpoint on the device
Enter the determined redox setpoint for your pool as follows:
To set, select Set points with
/
and confirm with
Setpoint
Set the redox setpoint using
/
and confirm with
.
Proceed as described in the previous chapter to determine the setpoint.
6.4.3
1-point redox calibration
1-point calibration is carried out with the 465 mV buffer solution provided. Alternatively, redox buffer solutions with other mV values can be used.
Never use buffer solution which is more than 12 months old.
To set, select Redox cal. with
/
and confirm with
.
1-point redox calibration
To set, select Offset (1pt) with
/
and confirm with
Current measurement
Shows what value is measured with the current setting.
Target measurement
Allows you to enter the redox buffer solution used.
After correct entry, confirm the calibration with