![background image](http://html1.mh-extra.com/html/bayrol/naturally-salt-salt-relax-power/naturally-salt-salt-relax-power_operating-and-installation-manual_2713062021.webp)
4 Operating the Salt Relax POWER
21
4.5
Service menu
Necessary qualification:
The Service menu and all settings made therein are reserved exclusively for the use of specialist service technicians/installation
engineers. Improper or incorrect settings will result in the loss of warranty!
This menu allows the following actions:
-
Activation and allocation of predefined external devices to relays (see diagram below)
-
Fine adjustment of the Salt Relax POWER
-
Configuration of the reactions of the Salt Relax POWER
-
Configuration of connected external devices (via 15 parameters)
-
Resetting of the operating hour counter
Access to the Service menu (for specialist service technicians/installation engineers only):
4.5.1
Relay configuration
The 7 relays available in the Salt Relax POWER can be assigned to various predefined external devices and activated via the Salt Relax POWER.
These predefined external devices are:
Relay
(designation in
the software)
Terminal
(designation on
the board)
External device / predefined function
Electr. circuitry
ph
PH
Dosing pump pH Minus / dosing pump pH Plus
230V/110V / 50Hz
Aux1
AUX1
Dosing pump pH Plus (for pH Minus AND pH Plus dosing)
230V/110V / 50Hz
Aux2
AUX2
Additional dosing pump for disinfection (to support the electrolysis cell)
230V/110V / 50Hz
Filter
FILTERPUMP
Filtration pump (circulating pump)
Floating switch
Light
LIGHT
Lighting
Floating switch
Aux3
AUX3
Not predefined
Floating switch
Aux4
AUX4
Heating (e.g. heat pump)
Floating switch
IMPORTANT!
Please note that this assignment should be adhered to when using the respective predefined function (e.g. filtration pump).
Free use of the relays Aux1, Aux2, Aux3 and Aux4:
In order to assign the relays Aux1, Aux2 and Aux4 freely, the predefinition of the respective device must be deactivated by selecting No in the Relay
configuration menu.
If a specific predefined function (see table) is assigned to relays Aux1, Aux2 and Aux4,
they do not appear in the main menu.
Relay Aux3 can be assigned freely without making further settings and is always visible in the main menu.
ATTENTION!
Make sure that only one function is assigned to each relay!
Multiple assignment will cause the relay to trip in accordance with each function assigned!
Password