Bayer HealthCare MEDRAD SCT 110, Operation And Installation Manual

Page: 12 / 30

MEDRAD
®
Stellant ISI 700 Module Operation and Installation Manual
6
Cautions System damage may occur if voltage is applied to J1 Pins 16, 18, 23, 25, 27, or 33. Only
connect these pins to isolated switch or relay contacts in the scanner.
Damage can occur as a result of incorrect voltage. Verify that the voltage and frequency
marked on the serial tag on the back of the unit matches the voltage and frequency of the
electrical outlet.
To remove main power from the equipment, disconnect the power cord from the appliance
inlet. Ensure the equipment is positioned so that the appliance inlet is accessible for power
cord disconnection.
System malfunction may be caused by failure to perform regular maintenance. Regular
preventive maintenance is recommended to ensure that the system stays calibrated and
functions properly. Refer to this manual or contact Bayer for additional information.
Do not expose system components to excessive amounts of water or cleaning solutions.
Disconnect power before cleaning. Wipe components with a soft cloth or paper towel
dampened with cleaning solution.
Do not use strong cleaning agents and solvents. Warm water and a mild disinfectant are all that
are required to clean the injector. Do not use strong industrial cleaning solvents such as
acetone.
NOTE: Bayer can only be responsible for proper injector and scanner
interaction if they are configured exactly as specified. The injector and
scanner will operate as described in this section only if the ISI module
is installed according to this manual and the scanner is capable of
accepting these signals via the interface.
Installation Caution: Equipment damage may result or system may fail to operate. The system is
meant to connect the following CT injection systems with a CT scanner and should not be used
with other medical devices or medical device technologies. Catalog Numbers:
SCT 110, SCT 111, SCT 112, SCT 120, SCT 121, SCT 122, SCT 210, SCT 211, SCT 212, SCT
220, SCT 221, SCT 222, SCT-310, SCT-321, SCT-322, FLEX, and FLEX UPG.
The ISI module kit contains the following items.
1. ISI module assembly
2. Power cord
3. Injector to ISI cable
4. ISI Module Operation and Installation Manual (this manual)
5. ISI Communication Safety Label (used on Certegra Workstation only)