Bay Networks Remote Annex 4000, Hardware Installation Manual

Page: 61 / 162

2-23 Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
Installing to and Loading from a VAX VMS Host
This section contains a description of what you need to do to install
the Remote Annex 4000’s operational software and image on a VAX
VMS Load Host. Refer to the Annex Interface for VMS Environments
Administrator’s Guide and the Annex Interface for VMS Environments
User’s Guide for additional information.
This product cannot be installed on an AXP system. This section
contains the following subsections:
❑
Installing the Operational Software and Image on a VAX VMS
Load Host.
❑
Configuring NCP for Downloading.
❑
Configuring for Crash Dump Support.
❑
Customizing for Multiple Remote Annex Images.
Installing the Operational Software and Image on a VAX VMS Load
Host
Prerequisites The following should be in place before you install the software and
image on your load host.
❑
Your load host must be running VMS 5.5 (or higher).
❑
Your load host must be running DECnet VAX

.
❑
The Ethernet controller must be on the same Ethernet as the
Annex.
❑
The CMKRNL and SYSPRIV privileges must be enabled.